Pages: [1]   Go Down
Author Topic: Could someone clarify how to connect these?  (Read 152 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

So I'm looking to add a touch screen to my project. I'm looking at this one http://www.adafruit.com/products/335

It says that you can add one of these http://www.digikey.com/product-detail/en/H3AAH-2006G/H3AAH-2006G-ND/1218466?cur=USD

But, Honestly, I'm not quiet sure how to achieve this, I want to keep all of my boards in an enclosure, and have this screen able to be remote accessed. Thanks for any clarification guys.
Logged

Atlanta, USA
Offline Offline
Edison Member
*
Karma: 53
Posts: 1777
AKA: Ray Burne
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The pin headers on the display would "plug-in" to the cable instead of the breadboard.  Pin headers would then be used on a circuit card (or breadboard) to connect the cable.

Logged

Pages: [1]   Go Up
Jump to: