Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Best Display with Arduino - to use ?  (Read 215 times)
0 Members and 1 Guest are viewing this topic.
gnusso
Offline Offline
Sr. Member
****
Karma: 2
Posts: 354
View Profile
« on: January 16, 2013, 06:46:50 am »
 Bigger Bigger Smaller Smaller Reset Reset
Good Morning Folks,
I'd like to know which is the best display to use with Arduino ...

In particular in my sketch I'm using several library:

- Virtual Wire
- Keypad
- DataTime.h
- DS1307.h

I'd like to know if can be particular issues with that library,

Thanks
Andrea
Logged

johnwasser
Massachusetts, USA
Offline Offline
Tesla Member
***
Karma: 96
Posts: 6367
View Profile
« Reply #1 on: January 16, 2013, 09:25:58 am »
 Bigger Bigger Smaller Smaller Reset Reset
The only issue I have heard about is some "I2C" serial LCD's not having an I2C address and therefore not playing nice with other I2C devices like the RTC.  A normal 6/10-pin parallel LCD should not cause that problem.
Logged

CrossRoads
Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 242
Posts: 16504
Available for Design & Build services
View Profile
WWW
« Reply #2 on: January 16, 2013, 10:47:55 am »
 Bigger Bigger Smaller Smaller Reset Reset
If a serial display is used, there should be minimal issues.
http://www.newhavendisplay.com/serial-displays-c-253.html

Will leave you the most pins free for the keypad:
Virtualwire - 2 pins (D11, D12 are the default)
DS1307 -2 pins (A4/A5)
Display - 2 pins, can be D0, D1
Keypad - 14 left for up to a 7x7 keypad (or 8x6, 9x5, 10x4, etc).
Logged
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: