Go Down

Topic: Eagle Cad problem using connectors (Read 347 times) previous topic - next topic

HugoPT

Hello all
Today I'm geting crazy with eagle.I need to put a connector with 6 pins that I found on con-molex library named 22-23-2061.
My problem is I can´t grab a wire on the terminals. I already tried use a wire and the button side a draw a BUS, named draw net.
I already tried another terminals but the problem is the same.
When I hit the wire near the terminal pin it won't grab it.Even if I zoom and place the wire above it if I move the connector aside  the wire don´t go with the connector as expected.
Debian,Mint,Ubuntu
Arduino Mega 2560
Arduino Nano
Arduino Duemilanove
MAC OS Montain Lion
Raspberry PI Model B

MarkT

You are trying to connect to the wrong end?  Its the thin red line that's the bit you connect to - the fat ends are just drawings
to symbolize the connector.
[ I won't respond to messages, use the forum please ]

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy