Go Down

Topic: Looking for help to set up an open source charge controller shield + vt100 emula (Read 3 times) previous topic - next topic


I'm looking at the possibility for ethernet support on the panel ... to get multiple commuinication options, looks like a mega is required (or other large footprint)  there seems to be a difference in how SPI is handled from small to large footprint of arduino.  One shield claims use of digital pins 10,11,12,13 ... I assume those are SPI for small footprint. Looks like SPI on large footprint is 50,51,52,53  ... I don't suppose anyone has tried or heard of anyone using both a tft shield and an ethernet shield on the same controller?

Go Up

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

shortcuts: alt+s submit/post or alt+p preview