Go Down

Topic: Debug output window buffer (Read 1 time) previous topic - next topic

erni-berni

Hi,
everytime I use the debug mode when uploading I am annoyed about that the window buffer of the output window is too small to hold the debug output, even then when uploading the only the small blink sketch.
Also I find that the -v-v-v-v mode gives too much information.
Can I enlarge the window buffer?
Is it possible to change to -v-v verbose mode?
Any other solution possible?
Regards
Reinhard

robtillaart


in the preferences.txt file add/change this line

console.length=500

Note that the IDE must be closed when editing this file..

BTW not tried higher values..
Rob Tillaart

Nederlandse sectie - http://arduino.cc/forum/index.php/board,77.0.html -
(Please do not PM for private consultancy)

erni-berni

I tried console.length=50000.
Works well also with long outputs

Meanwhile I found a second way to bypass the problem
In my Ubuntu installation the IDE creates a directory at \tmp named "console<some numbers>.tmp"   
In this directory you will find two files containing the information from the output/debug window.
The directory is deleted when you quit the IDE.

Now only one question is open:
Is it possible to change to -v-v verbose mode?

WizenedEE


I tried console.length=50000.
Works well also with long outputs

Meanwhile I found a second way to bypass the problem
In my Ubuntu installation the IDE creates a directory at \tmp named "console<some numbers>.tmp"   
In this directory you will find two files containing the information from the output/debug window.
The directory is deleted when you quit the IDE.

Now only one question is open:
Is it possible to change to -v-v verbose mode?


Not without recompiling the IDE unless you get version 1.5

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy