Pages: [1]   Go Down
Author Topic: Sound controlled actuator art project  (Read 2035 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am new to working with arduinos, I hope that this is the correct place to post this. I am a mechanical engineering student and I am attempting to help a graduate art student with a project. The project involves driving an array of linear actuators (we are thinking possibly 4x4). We would like the actuators to respond in real time to environmental sounds.

Ideally we would like the actuators to respond to different bandwidths of sound perceptible to humans. As I said, I am new to arduino as well as programming. I am not sure of the best way to accomplish this and I would appreciate any advice anyone can offer.

Possible ideas include FFT algorithms (of which I know little about) or individual bandpass filter circuits that would drive each actuator.

Thank you in advance for any help

Massachusetts, USA
Offline Offline
Tesla Member
Karma: 212
Posts: 8967
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

This might help:

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Left Coast, CA (USA)
Offline Offline
Brattain Member
Karma: 361
Posts: 17301
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

FFT algorithms can be quite challenging to run on an arduino board. There is a useful hardware audio spectrum breakout chip that many have used in application like yours.


Pages: [1]   Go Up
Jump to: