Once you have your robot hand
how do you get the wires out of the servo motor
I got the red wire out successfully, and when I put it into 5V, it felt pretty loose. Is it supposed to feel that way?
Why did you remove the wire from the socket? What do you intent to attach it to?
Well normally at this stage of your project, you'd be more likely to use some breadboarding wire to stick into the servo's socket and then attach those wires to whatever is going to power the servo - which should not be the arduino - it can't provide sufficient current for more than one, if that.Later you might wire it up using a male connector into the servo's socket so that it's easier to replace the servo from your robot if it is damaged, or solder it all together if you decide you don't need that luxury.
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16