Go Down

Topic: Two EZ-Robot S08NF STD servos committed suicide? (Read 1 time) previous topic - next topic

jeffmorris

While I was building and testing my new biped robot, I thought that two EZ-Robot S08NF STD servos committed suicide. I tried to test them on Arduino Uno board with Servo Sweep code but they don't work. I tested a Futaba S3003 servo on that board and it worked. I tested that servo on Dagu Spider Robot Controller which is based on Arduino Mega 1280 board and it worked. Did the EZ-Robot S08NF STD servos committed suicide?

Zapro

What did you use to power them ? What voltage ?

// Per.

jeffmorris

I was using 7.2VDC battery pack usually used for RC cars.

zoomkat


I was using 7.2VDC battery pack usually used for RC cars.


What is the max/min voltage ratings for your servos?
Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   8)

Zapro

Most servos cannot handle more than 6V, so you probably just killed them.

// Per.

Go Up