Go Down

Topic: Thermistor give stanges reading when useing and ethernet shield (Read 317 times) previous topic - next topic

I am very new to this but I have managed to get reasonably accurate temperature reading using a thermistor. However, if then connect an ethernet shield (I'm hoping to publish temperature reading to MQTT) and then connect the thermistor in the same way, the readings are way off. Does anyone have any ideas? I would be very gratefull for some advice.

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy