Pages: [1]   Go Down
Author Topic: External ICSP connection - is there a recommended way, or standard?  (Read 388 times)
0 Members and 1 Guest are viewing this topic.
Brisbane, Australia
Offline Offline
Edison Member
Karma: 33
Posts: 1123
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


What do you recommend as an external connector for an ICSP header on a project enclosure?  Until now I've socketed ATTiny uCs and added an internal FTDI header on ATMega based projects but this isn't convenient for updating code if necessary, nor keeping enclosures weatherproof. 

I googled for ideas without too much success.  What is considered best practice?


"There is no problem so bad you can't make it worse"
- retired astronaut Chris Hadfield

Left Coast, CA (USA)
Offline Offline
Brattain Member
Karma: 362
Posts: 17305
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I would consider the 6 pin RJ-12 connector system. That way you can use standard phone extensions cabling.

« Last Edit: January 08, 2013, 03:02:33 am by retrolefty » Logged

Offline Offline
Faraday Member
Karma: 68
Posts: 2853
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have used din connectors, the socket looks quite good on a case.
They are however, a bit large.

The way you have it in your schematic isn't the same as how you have it wired up! That goes for me too.

Pages: [1]   Go Up
Jump to: