Pages: [1]   Go Down
Author Topic: Battery Type  (Read 454 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am working my first project a 8 servo(FutabuS3004) quad walker and was wondering what would be a good LiPo battery would be for those? I am using the Mega and that is powered with a small pack I got from Liquidware.
Logged

Dubuque, Iowa, USA
Offline Offline
Edison Member
*
Karma: 45
Posts: 2474
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What are you using now for a battery pack (link to the product?) and what is your goal for your next battery pack? I assume you're looking for more run time; detail as to how much run time you have now and how much you want is the question.
Logged

California
Offline Offline
Sr. Member
****
Karma: 3
Posts: 433
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

http://www.ebay.com/itm/360507624892
I just got one of these. It's a gamble, I hear sometimes they bloat up or catch fire. But mine seems find so far except that I can't figure out how the indicator lights work.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I dont have any battery as of yet and the servo's voltage run between 4.8-6.0, I was thinking something like 5000mAh 50C 7.4V  would do.
Logged

Denmark
Offline Offline
Edison Member
*
Karma: 35
Posts: 1058
Happy Hobbyist
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
I was thinking something like 5000mAh 50C 7.4V  would do.

If that is a 2 cell  LiPo pack (which I asume from the 7,4V rating) you should rember that when fully charged the voltage will be 8,4V, which is too much for your servos. You will need something like this:

http://www.hobbyking.com/hobbyking/store/__4319__TURNIGY_3A_UBEC_w_Noise_Reduction.html

That one is only rated a 3A, which may not be enough, depending on how many servos are used at the same time, and how much load you put on them.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 9
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What I was looking at was the below link and thinking just dropping the voltage via a resistor.

http://www.hobbypartz.com/98p-50c-5000-2s1p-hardcase-2222-direct.html
Logged

Dubuque, Iowa, USA
Offline Offline
Edison Member
*
Karma: 45
Posts: 2474
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What I was looking at was the below link and thinking just dropping the voltage via a resistor.

Use a "BEC" (also called "UBEC") as Erni suggested. Definitely do not use a resistor.

The battery pack you have linked is rated at 50C meaning it can discharge 50 times its capacity (in short bursts) or 250 amps. This is way over the amperage you'd need; you can save a little money by finding one with a lower C rating.
Logged

Pages: [1]   Go Up
Jump to: