Pages: [1]   Go Down
Author Topic: Bootloader  (Read 938 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Jr. Member
Karma: 0
Posts: 76
just sun
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey Community :-)

i was on the search of how to burn bootloaders to fresh microcontrollers.
on the side of the boards it is always linked to
but this side redirects to
i think it should link to the Uploading part in the document:

In the Tools Section are also two link pointing to the Tutorial/Bootloader page  - that means they pointing to the same document you reading in  smiley-confuse
For selecting a harware programmer when programming a board or chip and not using the onboard USB-serial connection. Normally you won't need this, but if you're burning a bootloader to a new microcontroller, you will use this.

Burn Bootloader
The items in this menu allow you to burn a bootloader onto the microcontroller on an Arduino board....

is there some where some more information on the concept of the bootloaders for the different boards?

sunny greetings

Pages: [1]   Go Up
Jump to: