Pages: [1]   Go Down
Author Topic: Unmanned Quad Copter Project  (Read 2059 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all,

I'm currently working on a project where I am making a quadcopter.  This copter only needs to be able to lift off the ground for a few seconds and then set down safely.  I am currently using a Chip Kit Max32 and will be controlling the 4 motors with a motor driver.  What is the easiest way I can program this and set it up to give me my desired results?  Thanks a lot for all your help.
Logged

Seattle, WA USA
Offline Offline
Brattain Member
*****
Karma: 601
Posts: 48543
Seattle, WA USA
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
What is the easiest way I can program this and set it up to give me my desired results?
Perhaps your local Ford dealer could help. Why would you ask questions about some non-Arduino board here?
Logged

Global Moderator
Offline Offline
Brattain Member
*****
Karma: 474
Posts: 18696
Lua rocks!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

http://chipkit.net/forum/
Logged

Offline Offline
Edison Member
*
Karma: 8
Posts: 1341
If you're not living on the Edge, you're taking up too much space!
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The code is similar!  Some of the autonomous code I have written for Arduino actually runs better on a ChipKit because it's faster.  You can change the loop delay and everything else works.
Logged

If you fall... I'll be there for you!
-Floor

Skype Brighteyes3333
(262) 696-9619

Pages: [1]   Go Up
Jump to: