Pages: [1]   Go Down
Author Topic: amplifier for pt100  (Read 6931 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

can anyone suggest an amplifier for a pt100 thermocouple 3 leadshttp://www.virtualvillage.com/thermocouple-temperature-probe-pt100-003820-034.html

also please explain how to wire one to an arduino

general advice much appreciated

I am a complete beginner (electronics, arduino, programing)

thanks
« Last Edit: June 12, 2011, 11:18:58 am by asdfasdfasdf » Logged

0
Offline Offline
Edison Member
*
Karma: 8
Posts: 1040
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset


Logged

Trabajando en ...

    * Control Domotico (En montaje ...)
    http://casitadomotica.blogspot.com/
 

[url=https://bitbucket.org/fmalpartida

Offline Offline
Newbie
*
Karma: 0
Posts: 6
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset




So a bigger noob asks this question:

Where are the leads for the PT100 and the arduino input pins?

Thank you.
Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 361
Posts: 17263
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

The signal named ADC is what wires to a arduino analog input pin as well as the ground pin and the +5vdc. The PT is the top right component in that drawing. But without knowing the values for the R3 and R4 resistors it may be hard to get the circuit working correctly.

Lefty

Logged

Pages: [1]   Go Up
Jump to: