Go Down

Topic: Bootloader (Read 1 time) previous topic - next topic


Hey Community :-)

i was on the search of how to burn bootloaders to fresh microcontrollers.
on the side of the boards it is always linked to
but this side redirects to
i think it should link to the Uploading part in the document:

In the Tools Section are also two link pointing to the Tutorial/Bootloader page  - that means they pointing to the same document you reading in  :~
For selecting a harware programmer when programming a board or chip and not using the onboard USB-serial connection. Normally you won't need this, but if you're burning a bootloader to a new microcontroller, you will use this.

Burn Bootloader
The items in this menu allow you to burn a bootloader onto the microcontroller on an Arduino board....

is there some where some more information on the concept of the bootloaders for the different boards?

sunny greetings

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131