Go Down

Topic: Breadboard-friendly power connectors? (Read 766 times) previous topic - next topic

JimboZA

Hey all,

I have a couple of the connector thingies shown in the attached pic- sorry for quality but it shows the problem which is that they don't fit breadboard power rails.

I know I can jam the wires into the holes, but that doesn't work with stranded wire. What do others do for power connections to breadboard? (No electronics required- I've just hacked an ATX PSU so I have various voltages (3v3, 5v and 12v) available.)
"Could you do the egg bacon spam and sausage without the spam then? "

No PMs for help please.
DO NOT power servos from Arduino 5V: give them their own power and connect the grounds.

spycatcher2k

I bonded one of these to a breadboard, and soldered jumper wires to the pins, and inserted them into the rails.
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

JimboZA

Yeah I was thinking something along those lines... blob of Araldite should do it.
"Could you do the egg bacon spam and sausage without the spam then? "

No PMs for help please.
DO NOT power servos from Arduino 5V: give them their own power and connect the grounds.

spycatcher2k

Yip - I got 2 - one on each power rail - can do 5V & 12V on same board ;-)
Drew.
http://www.uk-pcb.co.uk - My UK Based PCB Fab & Assembly Company
Design work undertaken
SMD & Thru-Hole assembly

LarryD

1. Mount the protoboard on a piece of plastic then add binding posts. Use a wire from the posts to the protoboard.
posts
2. Use male headers on the protoboard. Solder wires to and use female headers on the male  :smiley-sweat:
3. Make small PCB with male headers on the bottom. Mount the terminal block you show on the top of the PCB.
The way you have it in your schematic isn't the same as how you have it wired up!

JimboZA

Quote
Make small PCB


As the lady on 9gag says, "Ain't nobody got time for that!"  8)

"Could you do the egg bacon spam and sausage without the spam then? "

No PMs for help please.
DO NOT power servos from Arduino 5V: give them their own power and connect the grounds.

LarryD

Quote
As the lady on 9gag says, "Ain't nobody got time for that!" 

Or use:
http://en.wikipedia.org/wiki/Stripboard
The way you have it in your schematic isn't the same as how you have it wired up!

JimboZA

Quote
Or use:
http://en.wikipedia.org/wiki/Stripboard


Now that I have....
"Could you do the egg bacon spam and sausage without the spam then? "

No PMs for help please.
DO NOT power servos from Arduino 5V: give them their own power and connect the grounds.

cr0sh


I know I can jam the wires into the holes, but that doesn't work with stranded wire.


Then use solid core wire - or use a thin-enough gauge of stranded wire that you can tin the ends (and the tinned section will still fit).

I typically do one of the above, and use alligator clip jumpers from the PSU to the board. I generally will run the inputs to the positive and negative rails on opposite sides (so the alligator clips have less of a chance of shorting), then jumper on the opposite end of the board the other rails.
I will not respond to Arduino help PM's from random forum users; if you have such a question, start a new topic thread.

Go Up