Go Down

Topic: Using Arduino uno to burn bootloader error (Read 1 time) previous topic - next topic

be80be

Try to burn bootloader on to blank chips atmega328P

I get this error after about a minute
Quote

Error while burning bootloader
avrdude: stk500_getsync(): not in sync: resp=0x00



Coding Badly


Three possibilities...

• Wiring between the programmer (your Uno) and the target (the ATmega328P)

• Auto-reset not disabled on the programmer

• No external clock on the target

be80be

Auto-reset not disabled on the programmer I pulled the chip from the uno and hooked it up on the bread board with 16mhz crystal just as it is on the the uno Im doing it like this
http://www.gammon.com.au/forum/?id=11637


Coding Badly


When you wrote this...

Quote
Try to burn bootloader on to blank chips atmega328P


...did you actually mean something like this...

I burned the bootloader on to blank atmega328P chips as describe by Nick Gammon on his site (http://www.gammon.com.au/forum/?id=11637).  When I try to use the chips, I get this error...

strykeroz

Are you using Nick's sketch? That doesn't look like one of his errors, but one from the ArduinoISP sketch?
"There is no problem so bad you can't make it worse"
- retired astronaut Chris Hadfield

be80be

I burned it with no problem on my old computer.

strykeroz


I burned it with no problem on my old computer.
Can you take a photo of your present setup and post that, along with confirmation of the actual sketch you're using?
"There is no problem so bad you can't make it worse"
- retired astronaut Chris Hadfield

be80be

#7
Jan 13, 2013, 05:10 am Last Edit: Jan 13, 2013, 05:25 am by be80be Reason: 1
I hooked the board as in the picture I posted in post 2 I used the sketch that comes with the arduino ide ver 1.0.3  windows 7

It's just sat there and then it would pop up a error that I posted changed to my old laptop which has ver1.0.2 of the ide and windows XP  and it happly burned all 3 chips .
Code: [Select]
// ArduinoISP version 04m3
// Copyright (c) 2008-2011 Randall Bohn
// If you require a license, see
//     http://www.opensource.org/licenses/bsd-license.php
//
// This sketch turns the Arduino into a AVRISP
// using the following arduino pins:
//
// pin name:    not-mega:         mega(1280 and 2560)
// slave reset: 10:               53
// MOSI:        11:               51
// MISO:        12:               50
// SCK:         13:               52

Go Up
 

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.
Name:
Email:

shortcuts: alt+s submit/post or alt+p preview