Pages: [1]   Go Down
Author Topic: Arduino Uno, Arduino Motor Shield, and H-Bridge used to control 24v DC Motor  (Read 1144 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am a newbie. I heard that Arduino is an open source environment. I have a Uno rev 3 and Motor Shield. I want to run a DC motor of 24 volts and 14 amp in both directions. I am very lost on thought on how to make this work with the motor shield or without, or even with another microcontroller. I have also tried creating an h-bridge on a breadboard and working off that. DC Motor Details:

Model: MY1025
Voltage: 24 V
Current: 14A

Any tips or ideas? References would be good as well. Thank you

Offline Offline
Tesla Member
Karma: 145
Posts: 9686
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

H-bridges on ebay


Consider the daffodil. And while you're doing that, I'll be over here, looking through your stuff.   smiley-cool

Pages: [1]   Go Up
Jump to: