Go Down

Topic: Mega(1280) not showing up in Tools > Serial Port (Read 231 times) previous topic - next topic

cthomas343

I am having trouble programming my Arduino MEGA(1280).  I just used my UNO to put the bootloader on it using <http://www.gammon.com.au/forum/?id=11635>.  I didn't receive any errors, and it looks like it was verified.

I then tried plugging the MEGA into my USB port, but it didn't show up under the Arduino 1.0.5 IDE on Windows 7.  I went into Device Manager, and the board is showing up as "FT232R USB UART".  Does anyone know how to make it show up in the IDE to upload sketches?

Go Up