Go Down

Topic: piezoelectric actuator - ARDUINO (Read 1 time) previous topic - next topic


Hi :
I want to test a piezoelectric actuator using Arduino. The question is : For testing the piezoelectric actuator I need AC voltage between -2 to 2 volts.
is It possible to do that test using Arduino????
Thank you for your advice.


is It possible to do that test using Arduino????


Of course, you'll need external hardware to go along with the Arduino. Google op-amp. Or maybe oP-aMp.


What do you mean by piezoelectric actuator? If it's just a regular buzzer, then
just connect it to an Arduino output pin.


what frequency of "AC"  do you think you need ? 

Go Up

Quick Reply

With Quick-Reply you can write a post when viewing a topic without loading a new page. You can still use bulletin board code and smileys as you would in a normal post.

Warning: this topic has not been posted in for at least 120 days.
Unless you're sure you want to reply, please consider starting a new topic.

Note: this post will not display until it's been approved by a moderator.

shortcuts: alt+s submit/post or alt+p preview