Pages: [1]   Go Down
Author Topic: Why can't I connect 3+ servo's to arduino? How to get around that  (Read 404 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am aware the Arduino only supplies up to 5v (I think) so that's probably why I can't connect 3 or more servos to it (right?)

But how do I get around that? any replies would be much appreciated
Logged

Offline Offline
Faraday Member
**
Karma: 60
Posts: 3242
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

No, it's current that's in short supply, not voltage.

A 5v supply could supply that 5v to loads of devices, provided the total current consumed was less than the maximum current the source can supply.

Hook the servos to their own 5v supply (servo red wire), control the servos from whatever pins you choose (the yellow wire) via the servo library, hook the servo power suppply to the servo ground wire (black) and lastly join the Arduino ground to the servo supply ground
Logged

Retired from Arduino.
PMs are set to ignore all.

Offline Offline
Faraday Member
**
Karma: 60
Posts: 3242
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

PS: Have a look at Duaneb's tutorial
Logged

Retired from Arduino.
PMs are set to ignore all.

Offline Offline
Newbie
*
Karma: 0
Posts: 11
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

hey thanks thats a great solution
Logged

Pages: [1]   Go Up
Jump to: