Go Down

Topic: DIY PCB transfer media (Read 3 times) previous topic - next topic


I use a dremel with the thinnest cutting wheel I have. It's certainly not the best way, I'm sure, but I can't think of any other ways to cut out an exact shape. Just gotta make sure I hold my breath!


Meh, that's what I do too.  It sucks when I'm trying to cut a board apart several inches deep, since I can't ever get the Dremel at a perfect 90 to the board.  (The tool's body is larger than the wheel diameter.)


Why not clamp it in place and take a hacksaw to it? That's what I do.
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.


I use a Jig Saw. 

Though I'm tempted to make something like this.


All done.

After etching.

Finished board. (Hope it works!)

- Scotty

Go Up