Go Down

Topic: ITG3200 gyroscope simple question (Read 412 times) previous topic - next topic

I want to change the address of the gyroscope from 0x69 to 0x68. I read in the description that it can be done by pulling the AD0 (pin 9) in the gyroscope to ground instead of Vcc using a jumper on the top of the board. Do anyone know exactly how this can be done cause I don't want to burn it?
I'm not sure if it's allowed to post links here but you can find the gyroscope in the first link (sparkfun) if you just google itg3200. This is written in the third paragraph.


Here is a photo f the gyro anyway:



Thanks in advance.

 

Krodal

If you look at the schematic at the sparkfun site ( https://www.sparkfun.com/products/9801 ) you see a solder jumper for AD0. You have to remove the connection to Vcc and make a connection to GND.

That solder jumper is the one with three pads near the Vdd pin.

Quote
If you look at the schematic at the sparkfun site ( https://www.sparkfun.com/products/9801 ) you see a solder jumper for AD0. You have to remove the connection to Vcc and make a connection to GND.

That solder jumper is the one with three pads near the Vdd pin.


Thanks a lot. it's clear now :)

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy