Go Down

Topic: Parts list (Read 337 times) previous topic - next topic

bkvaluemeal

I just want to confirm, will these parts work together correctly? Do I need anything extra, or is there anything that I don't need to build an Arduino without the blue board?

x1 ATmega328P-PU http://www.mouser.com/ProductDetail/Atmel/ATMEGA328P-PU/?qs=sGAEpiMZZMtVoztFdqDXO6rEZqxeooRg
x1 16MHz Crystal http://www.mouser.com/ProductDetail/CTS-Electronic-Components/ATS16B/?qs=sGAEpiMZZMsBj6bBr9Q9aSLORZG%2fS%2fcqdBLxnWFvQvI%3d
x2 22pf Ceramic Disc Capacitors http://www.mouser.com/ProductDetail/Xicon/140-50N5-220J-RC/?qs=sGAEpiMZZMt1mVBmZSXTPPQUnq7ol7tGNTXXR8EPBxs%3d

Also, can I use a usb power supply, or do I need a wall plug?

djjoshuad

you can use a USB power supply or a wall plug, but you'll need more components.  Do remember that you need to supply the correct voltage to the chip or you will be buying a new chip :)

bkvaluemeal

#2
Jan 14, 2013, 10:20 pm Last Edit: Jan 14, 2013, 10:26 pm by bkvaluemeal Reason: 1
USB is 5v @ ~500mA. That'll work wont it?

I'm reading a instructable, what other parts am I missing? The only thing else it says is power and a bread board, but I have both of those.

EDIT: Oh, and a usb to serial programmer...

djjoshuad

yes, you'll need the USB to serial board for initial programming, but not to run it. 

Also, you are correct the USB 5v will work just fine.  I only mentioned it b/c you said you were considering a wall adapter.

Good luck with your project!

bkvaluemeal

Thank you very much!

Go Up