Loading...
« previous topic   next topic »
Pages: 1 [2]   Go Down
Author Topic: Cutting a hole in a PC Board?  (Read 365 times)
0 Members and 1 Guest are viewing this topic.
oric_dan
the land of sun+snow
Offline Offline
Edison Member
*
Karma: 80
Posts: 2117
View Profile
WWW
« Reply #15 on: January 15, 2013, 04:05:30 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Hand reamer, cool idea. Can you get them in quarter size - about 25 mm?
Logged
Kitchen-Sink Arduino-compatible boards

CrossRoads
Global Moderator
Boston area, metrowest
Offline Offline
Brattain Member
*****
Karma: 242
Posts: 16485
Available for Design & Build services
View Profile
WWW
« Reply #16 on: January 15, 2013, 04:07:10 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Get a step-drill/Unibit & cordless screwdriver/drill, will do a nice job without grabbing & ripping.
Large diameters available.
Home Depot carries them.
Logged
Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17

Pages: 1 [2]   Go Up
Print
« previous topic   next topic »
 
Jump to: