Go Down

Topic: Best Display with Arduino - to use ? (Read 760 times) previous topic - next topic


Good Morning Folks,
I'd like to know which is the best display to use with Arduino ...

In particular in my sketch I'm using several library:

- Virtual Wire
- Keypad
- DataTime.h
- DS1307.h

I'd like to know if can be particular issues with that library,



The only issue I have heard about is some "I2C" serial LCD's not having an I2C address and therefore not playing nice with other I2C devices like the RTC.  A normal 6/10-pin parallel LCD should not cause that problem.
Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e


If a serial display is used, there should be minimal issues.

Will leave you the most pins free for the keypad:
Virtualwire - 2 pins (D11, D12 are the default)
DS1307 -2 pins (A4/A5)
Display - 2 pins, can be D0, D1
Keypad - 14 left for up to a 7x7 keypad (or 8x6, 9x5, 10x4, etc).
Designing & building electrical circuits for over 25 years.  Screw Shield for Mega/Due/Uno,  Bobuino with ATMega1284P, & other '328P & '1284P creations & offerings at  my website.

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131