Pages: 1 ... 5 6 [7]   Go Down
Author Topic: Implementation for Microchip ENC28J60 Ethernet controller  (Read 35102 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 10
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

If you have an Arduino Mega, you have to do a hardware hack to get it work, the link is given in th description of the library
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 34
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Has anyone experience with this library and the nanode ? (http://wiki.hackspace.org.uk/wiki/Project:Nanode)


Where can I buy a nanode for testing?
Nanode v5 ​​and nanode rf with the library Ethernet_ENC28J60 does not work.
Nanode and Arduino difference:
Pin 8 of the pin used by the microcontroller to select the ENC28J60 for the SPI bus.
Logged

Slovakia
Offline Offline
Newbie
*
Karma: 0
Posts: 1
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello all, any update on this? I'm using your library, with small upgrade as I needed e.print(float).

Additionally, everyone interested in ENC board, this works perfectly, and it's quite cheap + almost free shipping! 3.79€ + 0.50€

http://www.geeetech.com/arduino-enc28j60-ethernet-module-p-263.html
Logged

Pages: 1 ... 5 6 [7]   Go Up
Jump to: