Pages: [1]   Go Down
Author Topic: Mega2560 programmer upload problem  (Read 412 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, I have a Mega2560 here which I would like to bypass the bootloader adn upload using USBASP programmer. The Arduino software is the latest 1.0.3.

There was no problem to upload the bootloader and everything works fine after that. But when I upload the Blink sketch from the example using the programmer, it doesn't work. Not even after I cycle the power.

Is there anything that I miss out in order to upload using programmer?

Thanks!
« Last Edit: January 18, 2013, 12:49:45 am by haley0918 » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Nobody has a solution to this?
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I am having exactly the same problem. With the same programmer, it works fine on my Arduino Duemilanove though.
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 2
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Forgot to add details: win7pro 64 bit, Arduino 1.5.2, USBASP (Ebay clone) with latest firmware from fischl.de. Programming an arbitrary sketch into the MEGA328 on the Duemilanove works fine, and I can burn a bootloader into the MEGA2560 board successfully. But uploading a sketch into the MEGA2560 does not work, the board stays dead with the blink example and other sketches naturally don't load as well.
Logged

Pages: [1]   Go Up
Jump to: