Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: How to make Arduino IDE work with STM32 stamp module like ET-ARM STAMP ?  (Read 605 times)
0 Members and 1 Guest are viewing this topic.
ectar
Offline Offline
Newbie
*
Karma: 0
Posts: 16
View Profile
« on: January 19, 2013, 01:15:49 am »
 Bigger Bigger Smaller Smaller Reset Reset
How to make Arduino IDE work with STM32 stamp module like ET-ARM STAMP ?

Tried 1.5.1, No device found on COM8.

Is it even possible?
Logged

stonent
Offline Offline
Jr. Member
**
Karma: 0
Posts: 68
View Profile
« Reply #1 on: January 19, 2013, 01:29:40 pm »
 Bigger Bigger Smaller Smaller Reset Reset
The Arduino IDE is designed to program Arduino boards. The boards have a bootloader designed to let the Arduino IDE talk to it. But the Arduino IDE has to support via the compiler the chip on the board that you're trying to program.

Short answer, probably no, unless you write the software for it to happen.
Logged

stonent
Offline Offline
Jr. Member
**
Karma: 0
Posts: 68
View Profile
« Reply #2 on: January 19, 2013, 01:36:41 pm »
 Bigger Bigger Smaller Smaller Reset Reset
Actually looks like it may have been done.  I just googled et arm stm32 arduino and it was there (since 2009 looks like)

http://arttools.blogspot.com/2009/09/using-stm32-based-board-for-arduino.html

http://www.cutedigi.com/arduino/the-maple-stm32-arm-cortex-version-of-arduino.html
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: