Pages: [1]   Go Down
Author Topic: Arduino UNO Rev 3 polarity?  (Read 512 times)
0 Members and 1 Guest are viewing this topic.
universe
Offline Offline
Sr. Member
****
Karma: 0
Posts: 258
I'm enjoying my Life
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

I would like to ask simple question about arduino uno power jack polarity.
which is positive, the needle (at the center of the power jack hole) or the outer circle?
Thank you.
Logged

Offline Offline
Edison Member
*
Karma: 56
Posts: 2174
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

center is +
« Last Edit: January 19, 2013, 02:32:34 pm by LarryD » Logged

Left Coast, CA (USA)
Offline Offline
Brattain Member
*****
Karma: 331
Posts: 16518
Measurement changes behavior
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I would like to ask simple question about arduino uno power jack polarity.
which is positive, the needle (at the center of the power jack hole) or the outer circle?
Thank you.

Yes, positive. But if you were to wire a negative center pin voltage source via the connector there would be no damage as there is a on-board series polarity protection diode wired in to protect the board which will not function but will not be damaged by a negative center pin voltage source.

Lefty
Logged

universe
Offline Offline
Sr. Member
****
Karma: 0
Posts: 258
I'm enjoying my Life
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Thank you all! I just want to make sure everything is working in safety.
Logged

Pages: [1]   Go Up
Jump to: