Pages: [1]   Go Down
Author Topic: Arduino based RF controlled robot  (Read 1455 times)
0 Members and 1 Guest are viewing this topic.
India
Offline Offline
Newbie
*
Karma: 0
Posts: 8
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I'm trying to make bot using arduino duemilanove and L293D driver ,ht12e and ht12d with rx and tx reciever and transmitter modules but it doesn't seems to work. the motor driver doesn't responds...
somebody please guide me...
Logged

Seattle, WA USA
Offline Offline
Brattain Member
*****
Karma: 653
Posts: 50881
Seattle, WA USA
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
I'm trying to make bot using arduino duemilanove and L293D driver ,ht12e and ht12d with rx and tx reciever and transmitter modules but it doesn't seems to work. the motor driver doesn't responds...
No schematics + no links + no code == no help.
Logged

India
Offline Offline
Newbie
*
Karma: 0
Posts: 8
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

i need a circuit with these components to drive the bot using RF pin coneections how to drivel293d through atmega 328..tell me if anybdy can gve me circuit...or any link..
Logged

the land of sun+snow
Offline Offline
Faraday Member
**
Karma: 159
Posts: 2927
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

adafruit has a motor shield that uses the L293D chip. You can find information there.

http://www.adafruit.com/products/81

You also mention using RF transmitters. You should definitely take a project like this
in stages. 1: get Arduino and motor controller to work with hardwiring. 2: write a
separate program just to get the RF link communications working. 3: put 1+2 together.
« Last Edit: January 20, 2013, 09:51:11 pm by oric_dan » Logged

India
Offline Offline
Newbie
*
Karma: 0
Posts: 8
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

ya...I have a program for this bot....but still not able to drive the motor...thanks for advice I'll try going in stages.
Logged

Pages: [1]   Go Up
Jump to: