Pages: [1]   Go Down
Author Topic: Arduino stepper motor big and easy driveer  (Read 221 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 36
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey guys! I need some help. Here is what i have. https://www.sparkfun.com/products/10846 and https://www.sparkfun.com/products/10735

Here is what i have for setup.... I am using arduino uno. and the code im using for now is below. (i am using 9600 as well)
on the driver board i have the following

GNd to ground on the arduino Step to Pin 10 Dir to pin 9 ----------------------------COILS A Black & Green +++++++++++++++++ COILS B Red & blue --------------------------GND to ground on power supply (computer power supply) M+ to positive ( or +) of power supply

what in the heck am i doing wrong?????Here is where i found the coil config http://memakingthings.blogspot.com/2012 ... otors.html

And the code config http://www.instructables.com/id/How-to- ... /?ALLSTEPS

As for the powersupply here is the info on that. @ 5v i have 22A max (this is what im using)

Here is a pic of the connector im using. http://www.smpspowersupply.com/ATX-connectors.JPG

I am using paeripheral connector Red and black wire. and i have jumped the power supply and its on and running.

Can you guys help me out.
Logged

USA, FL
Offline Offline
God Member
*****
Karma: 14
Posts: 686
A life? Where can I download one of those?
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Copy and Pasting from the Sparkfun forums doesn't work so well, huh?

I replied to your Sparkfun post.  Do you want help here or over there?
Logged

//LiNK

Pages: [1]   Go Up
Jump to: