Pages: [1]   Go Down
Author Topic: Arduino 2 and printer 3d  (Read 794 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello ,
I want talk with people that have interesting for RipRap project .
What is the firmware that run with Arduino2 for this project and , particularly, The Mandel model ?
Tank’s
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,
might be that nobody is working with firmware of Arduino 2 for printer 3 D ?
If you're there, knock!
Logged

Offline Offline
Jr. Member
**
Karma: 5
Posts: 75
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi,

I am currently working on adapting the RAMPS printer control shield for Due. Soon I hope to start porting some RepRap firmware to the Due also. There is a web page http://reprap.org/wiki/RAMPS-FD describing the concept.

I'm currently working on porting Reprap firmware to an NXP ARM chip (LPC1114). Hopefully I will be able to make a multiplatform firmware to run on AVR, SAM3X or LPC11xx, possibly others, using ChibiOS. I've already done a Reprap firmware for STM32 using ChibiOS.
Logged

Pages: [1]   Go Up
Jump to: