Pages: [1]   Go Down
Author Topic: Switch and resistance  (Read 389 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all,
i am using Arduino Mega 2560, and i have a switching pcb. I will use 5V from Arduino, and i need a resistance beetween vcc and switches.
How much has to be the resistance?

Thanks in advance.
Nicola

* Cattura.JPG (0 KB - downloaded 14 times.)
Logged

Cumming, GA
Offline Offline
Edison Member
*
Karma: 20
Posts: 1653
Ultimate DIY: Arduino
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

A schematic will help here...

...having us trace a pcb for you to figure out what you intended it to do is needed before any advice is given.  Maybe someone else is willing to trace your PCB.
« Last Edit: April 22, 2013, 03:39:35 pm by pwillard » Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 5
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have two boards. The right board is the "master" and the left board sends to the right signals (i use flat cable). From the right board i send to Arduino signals. I'm using the Mux Shield to had multiple digital input tools.

I attached two photos of my pcb project. I hope my circuit goes well  smiley-confuse

dx.jpg is the right board
sx.jpg is the left board


* sx.JPG (74.59 KB, 265x589 - viewed 17 times.)

* dx.JPG (99.6 KB, 358x588 - viewed 19 times.)
Logged

Pages: [1]   Go Up
Jump to: