Pages: [1]   Go Down
Author Topic: 10 digit 7-segment wiring  (Read 281 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Karma: 0
Posts: 4
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, I'm working on a 10 digit display for a countdown and am new to electronics. After doing some research, I build up this diagram of a circuit and was wondering if anyone could confirm me if it could work? I also don't know which value should the resistors and capacitors have? I also left the data sheet of my 7-segments.

thanks for the help!

* 10_digit.jpg (493.61 KB, 2520x747 - viewed 15 times.)
* SDA-23.pdf (190.59 KB - downloaded 9 times.)

Massachusetts, USA
Offline Offline
Tesla Member
Karma: 212
Posts: 8974
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

That won't work.  To use a 595 with LEDs you need one resistor per LED. 

Be sure your LED's are Common Cathode if you are tying the Common to ground.  If you accidentally get Common Anode displays, just tie the common pins to +5 and the segment will light when the output pin is LOW.

Send Bitcoin tips to: 1L3CTDoTgrXNA5WyF77uWqt4gUdye9mezN
Send Litecoin tips to : LVtpaq6JgJAZwvnVq3ftVeHafWkcpmuR1e

Pages: [1]   Go Up
Jump to: