Loading...
« previous topic   next topic »
Pages: [1]   Go Down
Author Topic: Stacking boards without spacers and with corresponding pins not facing  (Read 142 times)
0 Members and 1 Guest are viewing this topic.
amundsen
unprobable country named Belgium
Offline Offline
Full Member
***
Karma: 0
Posts: 193
Ga bu zo
View Profile
« on: January 25, 2013, 02:37:41 am »
 Bigger Bigger Smaller Smaller Reset Reset
Hello,

I want to stack three boards : a Pro-Mini clone (Wattuino), a Drotek IMU and a BlueSmirf bluetooth board. I can stack the Wattuino and the Blue Smirf but I can't but the IMU in between because the pins for the connection between the Wattuino and the IMU are not all at a matching place. Also, there are no holes for spacers on both boards so I can't stack them with regular spacers and connect the boards with soldered cables directly.

Any suggestion ?

Thank you in advance.
Logged

oric_dan
the land of sun+snow
Offline Offline
Edison Member
*
Karma: 91
Posts: 2241
View Profile
WWW
« Reply #1 on: January 25, 2013, 03:23:30 am »
 Bigger Bigger Smaller Smaller Reset Reset
Pro-Mini mounts in a 24-pin 0.6" wide socket, doesn't it? Maybe buy an Arduino prototyping
shield, and mount the socket and everything else on that.
Logged
Something different - Kitchen-Sink Arduino-compatible boards

amundsen
unprobable country named Belgium
Offline Offline
Full Member
***
Karma: 0
Posts: 193
Ga bu zo
View Profile
« Reply #2 on: January 25, 2013, 04:56:44 am »
 Bigger Bigger Smaller Smaller Reset Reset
Mhhh... why not ? Thanks.
Logged

Pages: [1]   Go Up
Print
« previous topic   next topic »
 
Jump to: