Pages: [1]   Go Down
Author Topic: Mega2650 Driver Problem  (Read 326 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hey,
i have a Arduino Mega2650 with ATmega16u2 DFU... when i connect it to my PC it finds the ATmega16u2 DFU under "unknown devices"... then i go to uptdate driver and use the Mega2650 Rev3 driver from the Arduino pack... but now  i have an error CODE 10, not possible to start devices. Win 7 64 Bit oder my 32 Bit Notbook... all the same.

Is there a problem with the software on the ATmega16u2 DFU? The board was in a package for a reprap, so the Mega2650 works with LCD Display correct...
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

ok ok...

now i have find this post

http://arduino.cc/forum/index.php?PHPSESSID=74b6ee9ea1d3c42ab6e3973c6ca1299b&topic=141407.0

Have do the steps and now the RX/TX lamps flasch... but i think the Bootloader on the Mega2650 is missing to...
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

I have burned all µC again  and set the fuses. Now it works... it looks like the Atmega16u2 was not Programmend
Logged

Pages: [1]   Go Up
Jump to: