Go Down

Topic: atmega8 pinout (Read 2843 times) previous topic - next topic


I am doing it like here http://arduino.cc/en/uploads/Tutorial/SimpleBreadboardAVR.png but error is the same every time i try to upload program. maybe i could change something in library to fix this?


If you look on the ArduinoISP link I supplied it shows how to wire a breadboard chip to your UNO, Upload the ArduinoISP sketch, Install a capacitor between reset and ground on the UNO to prevent it resetting and then selecting correct target device in the IDE to program via the ArduinoISP sketch. I have done this with ATmega328, ATmega8 & ATtiny85 without problem. The most difficult job was finding a suitable bootloader for the ATmega8 chip to run 8Mhz internal clock but that was about a year ago now so probably no longer a problem.
I might seem like an idiot but remember it takes one to know one.
Forum user generally fall into three categories (the good, the bad & the a**hole) what category do you fit in?

Go Up

Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

via Egeo 16
Torino, 10131