Go Down

Topic: atmega8 pinout (Read 2884 times) previous topic - next topic

minoswydis

I am doing it like here http://arduino.cc/en/uploads/Tutorial/SimpleBreadboardAVR.png but error is the same every time i try to upload program. maybe i could change something in library to fix this?

Riva

If you look on the ArduinoISP link I supplied it shows how to wire a breadboard chip to your UNO, Upload the ArduinoISP sketch, Install a capacitor between reset and ground on the UNO to prevent it resetting and then selecting correct target device in the IDE to program via the ArduinoISP sketch. I have done this with ATmega328, ATmega8 & ATtiny85 without problem. The most difficult job was finding a suitable bootloader for the ATmega8 chip to run 8Mhz internal clock but that was about a year ago now so probably no longer a problem.
Once I almost saw Elvis but then my shovel broke. :(

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy