Pages: [1]   Go Down
Author Topic: Adding Beep to Every Second  (Read 817 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 17
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi, I wanted to know how I can add a 8 ohm speaker to the schematic (see the attachment below) so that the speaker beeps every second? Can you guys think of any methods of adding the speaker to this schematic which may involve an amplifier or any active device ( A device which changes the output signal, e.g 555 timer, amplifier, logic gates). Or I don't mind any other method as long as there is a speaker beeping every second. Thank You.



* Timer Pic.bmp (1125.05 KB, 800x480 - viewed 37 times.)
« Last Edit: January 24, 2013, 06:05:23 pm by 06awaism » Logged

Global Moderator
Boston area, metrowest
Online Online
Brattain Member
*****
Karma: 538
Posts: 27124
Author of "Arduino for Teens". Available for Design & Build services. Now with Unlimited Eagle board sizes!
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

The output from 555 pin 3 is once per second?
Use that to trigger a burst of oscillations on a 2nd 555 (or use a 556 in place of both) to create the tone for the speaker.
Logged

Designing & building electrical circuits for over 25 years. Check out the ATMega1284P based Bobuino and other '328P & '1284P creations & offerings at  www.crossroadsfencing.com/BobuinoRev17.
Arduino for Teens available at Amazon.com.

Pages: [1]   Go Up
Jump to: