Pages: [1]   Go Down
Author Topic: LiquidCrystal / TLV5618 Pins  (Read 809 times)
0 Members and 1 Guest are viewing this topic.
0
Offline Offline
Newbie
*
Karma: 0
Posts: 23
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello,

I'm using Arduino with the TLV5618 DAC which uses Digital Pins 10, 11 and 13.

I'd like to start using the LiquidCrystal library but notice that also uses Pin 11.

Is there any way I could swap Pin 11 to another Digital I/O on either of these without causing problems?

Thanks

J
« Last Edit: October 15, 2009, 11:33:53 am by ADJ_ADT » Logged

Manchester (England England)
Offline Offline
Brattain Member
*****
Karma: 639
Posts: 34726
Solder is electric glue
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

Quote
Liquidcrystal library but notice that also uses Pin 11.

I don't think it does, that is only in the example. As far as I am aware you can define any pins for use with the LCD library.

I suspect pin 11 is needed for the SPI part of the interface, that is fixed in the hardware.
Logged

0
Offline Offline
Newbie
*
Karma: 0
Posts: 23
Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Good news - cheers Mike.

J
Logged

Pages: [1]   Go Up
Jump to: