Go Down

Topic: Timing Problem with Lanc & pulsein (Read 1 time) previous topic - next topic

makru83

Hi Duane,

yes, that's the Code I am using since Yesterday which works great. Look at my Reply #8
The Arduino Mega still uses Pin 2 & 3 + extra Int Pins on 18-21
See -> http://arduino.cc/en/Reference/AttachInterrupt

But it is still driving me nuts that I am not getting your great Example to work, because I want to use the Code with an Arduino Mini 328, and might need more than 2 Channels,
but for now I am all good.

Thanks,
mario

DuaneB

Hi,
   So its the multi channel code that you are having trouble with ?

   At one time there was a bug in the pinchangeint library which stopped it working on some pins, which version are you using ?

   I will dig out a Mega tomorrow and get the code up and running just to make sure I haven't done anything daft my side - I use 328 based UNOs most of the time.

Duane B
 
Read this
http://rcarduino.blogspot.com/2012/04/servo-problems-with-arduino-part-1.html
then watch this
http://rcarduino.blogspot.com/2012/04/servo-problems-part-2-demonstration.html

Rcarduino.blogspot.com

makru83

I am using the latest Verion 2.19 beta of the PinChangeInt library.

I will get my 328 Micro Boards sometime this week, so currently I am stuck with the mega.

Go Up