Pages: [1]   Go Down
Author Topic: Is there a hardware test routine out there for an Arduino  (Read 310 times)
0 Members and 1 Guest are viewing this topic.
Australia/Austria
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset

After reading
http://ruggedcircuits.com/html/ancp01.html

and considering my projects (Long use, High voltage, non-standard wiring, mould growing  on the PCB and so on) I want to find or create a program just to check if all my pins are responding, timing is ok,and whatever other considerations i can check to reassure myself that my old workhorses are still reliable.

Its not that I am cheap, I have three already, but I like to know if I am breaking my OWN programs, or if one pin out of 19 is just a little fried.
I tend to use the materials at hand rather than buying a new setup to try a little idea

Can anyone recommend a sketch already out there, or advise what parameters I can check aside from a
 for(pins){blink}
Cycle?
Logged

oliver-kellow.com

Washington
Offline Offline
God Member
*****
Karma: 38
Posts: 790
Firefox & Arduino rocks
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Maybe look here: http://arduino.cc/forum/index.php/topic,50203.0.html ?
Logged

Avoid throwing electronics out as you or someone else might need them for parts or use.
Solid state rectifiers are the only REAL rectifiers.
Resistors for LEDS!

Pages: [1]   Go Up
Jump to: