Pages: [1]   Go Down
Author Topic: COM Port 3 Not Found?  (Read 609 times)
0 Members and 1 Guest are viewing this topic.
Missouri
Offline Offline
Newbie
*
Karma: 0
Posts: 14
If you accidentally pull a wire, make sure it's the volts in. *shrugs*
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hello!
I've been struggling to find an answer to this seemingly simple problem: My computer won't recognize COM Port 3. It recognizes my Uno as a device on COM3, but the IDE seems to not recognize it. I noticed the TX/RX lights aren't lightning, but this may just be because it's not receiving a signal... The board was working perfectly fine earlier today, but this problem began an hour ago. I've tried rebooting my computer, unplugging and replugging the cable, resetting the board, and updating the drivers; nothing works! If anyone can offer possibilities for why I'm getting this error, I'd be very thankful!!
Thanks,
Jared
Logged

Eeyup.

Global Moderator
Dallas
Offline Offline
Shannon Member
*****
Karma: 176
Posts: 12285
View Profile
WWW
 Bigger Bigger  Smaller Smaller  Reset Reset


http://arduino.cc/forum/index.php/topic,73748.0.html
...pass or fail?
Logged

Land of Oz
Offline Offline
Jr. Member
**
Karma: 3
Posts: 72
I dream in Assembler
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

What O/S are you using ?
This is with ref to windozeXP
What do you see in your Control Panel's -> System -> Device manager view of the com ports ?
Logged

Pages: [1]   Go Up
Jump to: