Go Down

Topic: Reset pin on ATtiny84 (Read 653 times) previous topic - next topic

Jack Christensen

That's probably a 100mA load, give or take. I'd try the 1K with one LED, measure the collector voltage, add a couple LEDs at a time. If the collector voltage doesn't get low enough to drive the LEDs bright enough, try one of those 330? guys on the transistor base instead. If that still doesn't achieve the desired results, then a different transistor might be in order.
MCP79411/12 RTC ... "One Million Ohms" ATtiny kit ... available at http://www.tindie.com/stores/JChristensen/

Ben1234

The leds should not draw more than 160ma (8*20ma) so hopefully it will work. The description said up to 200ma. Do you think that there might be a problem, though?

Jack Christensen

MCP79411/12 RTC ... "One Million Ohms" ATtiny kit ... available at http://www.tindie.com/stores/JChristensen/

Ben1234


Jack Christensen


Thanks for your help!!


Let us know if it was good help or ... otherwise XD
MCP79411/12 RTC ... "One Million Ohms" ATtiny kit ... available at http://www.tindie.com/stores/JChristensen/

Go Up