Go Down

Topic: Arduino and driver (Read 857 times) previous topic - next topic

Jan 30, 2013, 12:39 pm Last Edit: Jan 30, 2013, 01:06 pm by fulminator Reason: 1
Hello, I am new to Arduino and electronics. Right now I am making some experiences with: 1 DC small motor (here: http://dx.com/p/mini-electric-motors-set-black-3-pcs-154836) and a big old 9V stepper motor (4 wires: blue, white, red, yellow).

I have this driver: http://dx.com/p/l9110-dual-channel-h-bridge-motor-driver-module-for-arduino-black-157149.

I think I figured out how to make the connections, but I am very scared of burning my Arduino or something. I am new to electronics, as I said, and I manifest the fear of "don't burn anything".

So can you guys please guide me to make the connections? And a part of the code?

edit: I've put a scheme for the 9V stepper made in paint. Is that good?

ash901226

my answer is to follow what the picture said..... and double triple check ok  b4 you power on anything
make sure the batery and the power supply is the last thing you need to connect

ash901226

if you are using a breakout board usually they had include all the necessery precaution
you just need to take care so that the power and data line does not get mix up

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy