With the ZXLD1360, can I directly connect pwm output from an 3ch RGB controller to the 1360? They're not logiclevel (I think).
If I limit current to 300ma per color, could I then take the Blue from 3 of the RGB's connect to single 1360, do the same for RED, Green...thus needing only 6x1360s for a fixture with 6x3wRGB? Aka, run colors in series to each 1360 chip separately.
I will need to regulate before connecting to the ADJ pin bc the zxld1360's ADJ pin max is +6v.
Would I a pull-up in this scenario, like a 10k pull-up between ADJ and controller's output? would it be close to this model below? (each color 350ma)3ch RGB controller output1(12v >) -> 10kpull-up -> Adj 10kpullup -> c1=100nF -> Grnd
Please enter a valid email to subscribe
We need to confirm your email address.
To complete the subscription, please click the link in the
email we just sent you.
Thank you for subscribing!
via Egeo 16