Go Down

Topic: Nothing shows up in Serial Monitor (Read 667 times) previous topic - next topic

mascaproj13

Hello Firneds
HW Set up: Arduino BT board(Atmega 328); Computer has USB BT dongle;
SW set up: Arduino 1.0.3, Win vista;
Programming mode checked: AVRISP Mk2; Baud 9600;
Even for the following simple code the serial monitor does not give any out put. I try including <SoftwareSerial.h> and no luck.
Any suggestions please?

Code: [Select]
void setup() {
    Serial.begin(9600); // opens serial port, sets data rate to 9600 bps
    Serial.println("Hello Computer");
}

void loop() {

  Serial.println("Hello Computer");

}

James C4S

Capacitor Expert By Day, Enginerd by night.  ||  Personal Blog: www.baldengineer.com  || Electronics Tutorials for Beginners:  www.addohms.com

mascaproj13

Yes paired. Link is up when opening serial monitor. Able to download blink sketch. However no luck in making serial comm working. Thanks

Go Up
 


Please enter a valid email to subscribe

Confirm your email address

We need to confirm your email address.
To complete the subscription, please click the link in the email we just sent you.

Thank you for subscribing!

Arduino
via Egeo 16
Torino, 10131
Italy