Pages: [1]   Go Down
Author Topic: Motor shield R3  (Read 549 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all  smiley,
i've got a simple question does this motor shield handle unipolar only or bipolar only stepper motor ?
on the official page description it is mentionned unipolar; i'm about to buy a bipolar stepper motor (4 wires) because of its good characteristics for my project; will it work with that shield R3  smiley-roll ?
thx for your answer
Logged

Offline Offline
Faraday Member
**
Karma: 68
Posts: 2805
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Give us a link to your motor shield...
Logged

The way you have it in your schematic isn't the same as how you have it wired up! That goes for me too.

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thx LarryD for your interest, i'm just talking about arduino motor shield at -> http://arduino.cc/en/Main/ArduinoMotorShieldR3
in the section "Input and Output" they only talk about unipolar stepper, what about bipolar ?
Logged

Offline Offline
Sr. Member
****
Karma: 1
Posts: 282
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It will work.  I've done it already.  check out tutorial for instructions

http://www.instructables.com/id/Arduino-Motor-Shield-Tutorial/step4/One-Motor/\
Logged

peace*&^

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thx a lot ! this topic can be closed.
Logged

Pages: [1]   Go Up
Jump to: