Pages: [1]   Go Down
Author Topic: Motor shield R3  (Read 493 times)
0 Members and 1 Guest are viewing this topic.
Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Hi all  smiley,
i've got a simple question does this motor shield handle unipolar only or bipolar only stepper motor ?
on the official page description it is mentionned unipolar; i'm about to buy a bipolar stepper motor (4 wires) because of its good characteristics for my project; will it work with that shield R3  smiley-roll ?
thx for your answer
Logged

Offline Offline
Edison Member
*
Karma: 64
Posts: 2488
The last thing you did is where you should start looking.
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

Give us a link to your motor shield...
Logged

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thx LarryD for your interest, i'm just talking about arduino motor shield at -> http://arduino.cc/en/Main/ArduinoMotorShieldR3
in the section "Input and Output" they only talk about unipolar stepper, what about bipolar ?
Logged

Offline Offline
Sr. Member
****
Karma: 1
Posts: 273
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

It will work.  I've done it already.  check out tutorial for instructions

http://www.instructables.com/id/Arduino-Motor-Shield-Tutorial/step4/One-Motor/\
Logged

peace*&^

Offline Offline
Newbie
*
Karma: 0
Posts: 3
View Profile
 Bigger Bigger  Smaller Smaller  Reset Reset

thx a lot ! this topic can be closed.
Logged

Pages: [1]   Go Up
Jump to: